V9.7 01/05/20 UD0011 Page 23 of 177
This Document is uncontrolled when printed unless over stamped “CONTROLLED DOCUMENT"
7.1.6 FINGERPRINT ACCESS
1. Touch the screen to bring the system out of idle mode.
2. The reader will illuminate red. Place your finger on the reader.
3. Verify your user name on the touch screen.
7.1.7 FINGERPRINT AND PIN ACCESS
1. Touch the screen to bring the system out of idle mode.
2. The reader will illuminate red. Place your finger on the reader.
3. Enter your PIN and press
4. Verify your user name at the touch screen.
NOTE: There is an event within Traka Touch called ‘Duress via PIN +/-1’. This is triggered to notify a duress
situation. After a user has accessed the system either by card ID or fingerprint they must input their PIN
number + or - 1 digit of their actual PIN number to activate the event. For example, a PIN number, 2222
would be either 2223 or 2221.
To Next Page
Loading...
