M A N U A L C O N F I G U R A T I O N
22
DDNS Settings
Most internet service providers do not provide a static (dedicated) IP address.
Accordingly it can be difficult to remote access your camera. Dynamic DNS (DDNS)
is a free service that keeps track of your IP address, through these changes.
These instructions detail how to configure DDNS for your camera.
Note: DDNS is NOT required if you are using Yoics to remote access your
camera.
How to use www.dyndns.com for DDNS setting:
o This service is free. Please allow 24-48 hours for the server to activate your
account.
o Please go to http://www.dyndns.com/ and click on [create account].
o Enter information required at Create Your DynDNS Account page and click
[create account]
o You should receive a confirmation email within a few minutes. Please make sure
that your spam filter allows messages from support@dyndns.com to be received.
o Login to your account by using the username and password you created.
o Click on [my service] on the upper right corner.
o Click [add host name] under Host Services.
o Create your own host name such as xxx.dyndns.org
o Select Service type: Host with IP address.
o Click [Use auto-detected IP address] and click [create host]
o Review your host service information.
o Go to your DVR or IP cam’s webpage and select DDNS setting.
o Enter hostname, username, and password you created for DynDNS service..
o Click [save] to enable this service for your DVR or IP cam.
o Note that after you create an account, DynDNS might need 24-48 hours to
process and activate your service.
o To access your DVR or IP cam, instead of using your IP address, please go to your
host service: http://xxx.dyndns.org:100 (replace xxx with your host name, and
replace 100 with your port number)
o If you have questions about this service please contact DynDNS at
Dynamic Network Services, Inc.
1230 Elm Street, Fifth Floor
Manchester, NH 03101
USA
support@dyndns.com
Phone: +1-603-668-4998
Fax: +1-603-668-6474
To Next Page
Loading...
