Astra Mega I - Programming the Automatic Steam Wand

2. Setting the Accuracy Parameters
• Press and hold the “Set” button
• Display will read “Cor”
• Press “Set” button again
• Adjust the temperature between 0-20 degrees Fahrenheit
using the up or down arrows (default is set for 0 degrees
Fahrenheit)
• Once you have selected the desired temperature, press the
“Set” button.
3. Setting the Differential Te
mperature
• Press and hold the “Set” button
• Display will read “Dlf”
• Press “Set” again
• Adjust the temperature between 2-40 degrees Fahrenheit
using the up or down arrows
• Once you have selected the desired temperature, press the
“Set” button.
• The display will read “St.2”
• Press “Set” button again
• Display will show the selected temperature from step 1
• Press “Set” button to record the change
4.
Setting the Upper Limit Parameters
• Press and hold the “Set” button
• Display will read “St.H” (setting the highest temperature)
• Press “Set” button again
• Adjust the temperature between 0-950 degrees Fahrenheit
using the up or down arrows (suggested temp. is 250
degrees Fahrenheit)
• Once you have selected the desired temperature, press the
“Set” button to record the change.
5.
Setting the Lower Limit Parameters
• Press and hold the “Set” button
• Display will read “St.L” (setting the lowest temperature)
• Press “Set”
17