7
C
AUTION:Make sure that both of the portafilter wings are
securely aligned and that the portafilter has created a tight seal
with the group head gasket. If a tight seal is not created, a
potentially dangerous situation exists as hot water under pressure
could escape from the group head causing burn injuries. NEVER
remove a portafilter from the group head while it is under pressure
and brewing. Push the Brew/Stop button to stop brewing or wait
until the brew cycle stops.
Place an espresso cup under the portafilter. A single serving of
espresso is 1.5 to 2.0 ounces. Extraction time will be between 18 to
22 seconds. Push the first selection on the touchpad and
extraction will start. Once you have the right amount of espresso in
the cup, push the first selection again to stop the extraction. The
light for a single selection (on all touchpads) will start to blink. Once
the blinking stops and the light is off, the selection is now
programmed in all of the group heads.
Now use the double portafilter and complete the next selection
following the same steps. Repeat until all of the selections are
programmed. To exit the program mode, push and hold the
Brew/Stop button. All of the lights will come on and continue to
hold the button until the lights go out. Once the lights are out,
your selections are programmed and you have exited the
programming mode.
While the machine is extracting espresso, pump pressure gauge
will read approximately 135 PSI. On the front panel there are two
lights: green and amber. The green light indicates that the machine
is on while the amber light indicates when the heating element is
operating. The amber light will go on intermittently while the
machine is on regardless of whether it is in use or not.
To Next Page
Loading...
