Astralpool Eco Elyo-24 - Page 10

10
Maintenance
Press and hold
2s to turn o the
appliance
Disconnect the
power supply for
at least 3 minutes
Close valves A
and C and open
valves D and E (if
present)
Drain the
water from the
condenser to
avoid any risk of
freezing
Put on the winterising cover
• ln the case of full winterising for the pool (complete shutdown of the ltraon system, bleed the ltraon
circuit or even pool drainage): re-t the two connectors by one turn to prevent any foreign bodies from
geng into the condenser.
• ln the case of winterising for the heat pump only (shutdown of the heang only, the ltraon keeps
running): do not ghten the connectors but add 2 caps (provided) on the condenser’s water inlets and
outlets.
• Put on the winterising cover (provided) on the heat pump passing the hydraulics connecons up through the
opening provided for that purpose. It is not necessary to disconnect hydraulic and electrical connecons.
Winterising
• Winterising is vital to prevent the condenser breaking due to freezing (freezing without winterising
is not covered by the warranty).
• To avoid damaging the appliance with condensaon, do not fully caver it; use the provided
winterising cover.
• Do not disconnect the electricity supply when the appliance is running. If the electric power
supply is interrupted, wait a minute before restoring power to the appliance.
• Before any maintenance, troubleshoong or repair operaon, deacvang the modem’s Wi-Fi
connecon is recommended to avoid any risk of the appliance being remotely controlled.
• lt is recommended that the appliance undergo general servicing at least on a yearly basis to
ensure proper operaon, maintain performance levels and potenally prevent certain failures.
These operaons are carried out at the user’s expense by a technician.
❸
Maintenance
Refer to the online manual for
further details about safety
instrucons relave to R32
refrigerant and maintenance tasks
that have to be carried out by a
qualied technician.
Maintenance
• Make sure that the venlaon grid is not blocked by any foreign bodies.
• Clean the evaporator using a so brush and a fresh water spray (disconnect the power cable).
• Clean the condensate drainage line to remove any impuries that may be blocking it.
• Make sure that the switch box’s venlaon grid is clean.
• Do not use a high pressure jet. Do not spray with rain water, salt water or water which is full of minerais.
• Clean the outside of the appliance; do not use any solvent-based products. You can use a specic
cleaning kit as an accessory: the PAC NET.
6