ASUS A7N8X motherboard user guide
53
Second Boot Device [HDD]
This field sets the priority of the second boot device; by default, the system
boots up on the hard disk driver if the floppy drive is not present. Configuration
options: [Floppy] [LS120] [HDD] [SCSI] [CDROM] [ZIP100] [LAN] [Disabled]
Third Boot Device [LS120]
This field sets the priority of the third boot device; by default, the system
boots up on the LS120 if the flopyy and hard disk drive are not present.
Configuration options: [Floppy] [LS120] [HDD] [SCSI] [CDROM] [ZIP100]
[LAN] [Disabled]
Boot Other Device [Enabled]
By default, this field enables the detection of other devices, aside from the
first three priority devices. Configuration options: [Enabled] [Disabled]
Boot-up Floppy Seek [Enabled]
If enabled, this field speeds up the Power On Self Test (POST) routine by
skipping and retesting a second, third and fourth time. Configuration options:
[Enabled] [Disabled]
Boot-up NumLock Status [On]
This field sets the capability of the NumLock light/key to display/activate the
system. Configuration options: [On] [Off]
Gate A20 Option [Fast]
This field sets the gate A20 rate. The default is [Fast]. Configuration options:
[Normal] [Fast]
Typematic Rate Setting [Disabled]
This field enables or disable permission to change the rate of keystroke
registration and display. By default, the rate cannot be changed. Change to
[Enabled] to make settings in the nextt field. Configuration options: [Enabled]
[Disabled]
Typematic Rate Setting (Char/Sec) [6]
This field determines the number of keystrokes per second that the system
can register. Configuration options: [6] [8] [10] [12] [15] [20] [24] [30]
Typematic Delay (Msec) [250]
This field determines the delay time ( in milliseconds ) between registering a
keystroke and displaying it onscreen. Configuration options: [250] [500] [750]
[1000]
APIC Mode [Enabled]
This field enables or disables the APIC mode. Configuration options:
[Enabled] [Disabled]
To Next Page
Loading...
