60
Chapter 4: BIOS Setup
Parallel Port Mode [SPP]
This field sets the operation mode of the parallel port. The default, SPP,
enables normal-speed operation but in one direction only; EPP enables
bidirectional parallel port operation; ECP enables the parallel port to operate
in bidirectional DMA mode; ECP+EPP enables normal speed operation in a
both ECP and EPP modes. Select [ECP] to access the next field, “ECP
Mode Use DMA”. Configuration options: [SPP] [EPP] [ECP] [ECP +EPP]
ECP DMA Select [3]
This field sets the parallel port DMA channel for the selected ECP mode.
The default setting is 3. This selection is available only if you select [ECP] or
[ECP+EPP] in Parallel Port Mode above. Configuration options: [1] [3]
Onboard Game Port [201]
This field sets the address of the game port t0 201 by default. Disabling the
game port makes the port unavailable.
Configuration options: [Disabled] [201] [209]
Onboard MIDI I/O [330]
This field sets the address of the MIDI I/O port to 330 by default.
Configuration options: [Disabled] [330] [300]
Onboard MIDI IRQ [10]
This field sets the IRQ address of the MIDI port to 10 by default.
Configuration options: [5] [10]
To Next Page
Loading...
