ASUS A7N8X motherboard user guide
65
Set Supervisor Password / Set User Password
To set a password, highlight the appropriate field and press <Enter>. Type
in a password then press <Enter>. You can type up to eight alphanumeric
characters; symbols and other characters are not useable. To confirm the
password, type the password again and press <Enter>. The password is
now set to [Enabled]. This password permits full access to the BIOS Setup
menus. To clear the password, highlight this field and press <Enter>. The
same dialog box as above appears. Press <Enter>. The password is set to
[Disabled].
Security Option [Setup]
This field sets the security options. The default enables the setup option for
security. Configuration options: [Setup] [System]
Forgot the password?
If you forget a password, you can clear it by erasing the CMOS Real Time Clock (RTC)
RAM. The RAM data containing the password information is powered by the onboard button
cell battery.
NOTE: See section “2.7 Jumpers” for more information about how to erase the RTC RAM.
To Next Page
Loading...
