Asus A7S333 - Page 37

ASUS A7S333 motherboard user guide 25
A7S333
®
A7S333 Audio Codec Setting
AUDIO_EN
Disable
23
12
Enable
(Default)
A7S333
®
A7S333 Bass Center Setting
(CENTER/BASS)(BASS/CENTER)
1223
(Default)
BCS1
BCS2
BCS1
BCS2
5) Bass Center Setting (Two x 3 pin CENTER/BASS, BASS/CENTER)
(audio models only)
Use these jumpers in conjunction with the C-Media PCI Audio Driver and to
adjust output for 4 or 6 speaker audio. No audio standard exists for the three
pick-up surfaces on male audio jacks, therefore it may be necessary to switch
jumpers from the default position, [1-2], to [2-3], in order to reroute signals
among the internal leads in the Line-In, Line-Out, Mic female sockets.
6) Audio Setting (3 pin Audio_En)
The onboard 6 channel audio chip may be enabled or disabled using these
jumpers. The default, [2-3], enables the audio setting. Disable the onboard
audio system if using a PCI audio card on any of the expansion slots.