36
Chapter 2: Hardware information
A7S333
®
A7S333 Smartcard
SMARTCON
NC
SCRFET#
NC
NC
NC2
VCC
GND
SCRUI
SCRRES#
NC
SCRCLK
1
NC
SCRREST
A7S333
®
A7S333 IEEE-1394 Headers
IEEE-1394_1
Ground
Ground
TPA2+
TPA2-
TPB2-
TPB2+
Ground
+12V
IEEE-1394_2
Ground
Ground
TPA2+
TPA2-
TPB2-
TPB2+
Ground
+12V
IEEE-1394_3
Ground
Ground
TPA2+
TPA2-
TPB2-
TPB2+
Ground
+12V
17) Smart Card Reader Connector (14-1 pin SMARTCON)
This connector accommodates a Smart Card Reader that allows you to
conveniently make transactions such as financial, health care, telephony, or
traveling services through a Smart Card user interface software. When using
this connector, configure the UART2 Use As parameter in BIOS to set UART2
for use with Smart Card. See section “4.4.2 I/O Device Configuration” for
details.
18) IEEE-1394 Header (Three x 8-pin IEEE1394_1,2,3) (Optional)
This header supports an IEEE-1394 serial connector cable set that mounts
to a standard expansion slot in the computer case. 1394-compliant internal
fixed disk drives may also be connected to these headers.
To Next Page
Loading...
