Asus A8N-SLI DLX - Page 53

ASUS A8N-SLI DeluxeASUS A8N-SLI Deluxe
ASUS A8N-SLI DeluxeASUS A8N-SLI Deluxe
ASUS A8N-SLI Deluxe
2-272-27
2-272-27
2-27
11.11.
11.11.
11.
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature. See related BIOS item in
page 4-42.
Never connect a
USB cable USB cable
USB cable USB cable
USB cable to the IEEE 1394 connectors. Doing so will
damage the motherboard!
12.12.
12.12.
12.
IEEE 1394 connector (10-1 pin IE1394_2)IEEE 1394 connector (10-1 pin IE1394_2)
IEEE 1394 connector (10-1 pin IE1394_2)IEEE 1394 connector (10-1 pin IE1394_2)
IEEE 1394 connector (10-1 pin IE1394_2)
This connector is for the IEEE 1394a module. Connect the IEEE 1394
module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
A8N-SLI DELUXE
®
A8N-SLI DELUXE Chassis alarm lead
CHASSIS
+5VSB_MB Chassis Signal GND
(Default)
A8N-SLI DELUXE
®
A8N-SLI DELUXE IEEE 1394 connector
IE_1394_2
1
GND
+12V
TPB1-
GND
TPA1-
+12V TPB1+ GND TPA1+