English
6
5
Connect drive signal cables
1. Connect the floppy disk signal cable. Make sure the side of the
cable with the colored stripe is plugged into pin 1 of the floppy
disk connector.
2. If you are using IDE hard disk drives, connect the IDE signal
cable. Make sure the side of the cable with the colored stripe is
plugged into pin 1 of the IDE connector.
3. If you’re using SATA hard disk drives, connect the SATA signal
cable. The SATA connector fits only in one orientation. If the
connector doesn’t fit, try reversing it.
Floppy disk
Serial ATA
IDE
To Next Page
Loading...
