Chapter 1 Introduction
1.1 About this Document
This document is included as a supplement to the product manual for the UP Xtreme
(UP-WHL01). If you do not have the product manual for your device, please visit the
product page on AAEON.com to download the full version.
This document is intended for use only with the UP Xtreme product manual and is not
for use as a separate document nor for use with any other product. If you have any
questions regarding this document or your AAEON product, please contact your
AAEON sales representative for assistance.
Chapter 2 CEC-Client Installation
2.1 Introduction
CEC-Client is required to allow your PC to send custom CEC commands to a
connected TV using a CEC adaptor. This section details installation instructions for
CEC-Client.
2.2 Windows Installation
CEC-Client is an exe file included in the libCEC-AAEON library. Microsoft Visual Studio
(for C++) is required to install and run CEC-Client on Windows. During installation,
libCEC-AAEON Setup will check for Microsoft Visual Studio during installation. If
Microsoft Visual Studio is not detected on your device, the required packages will be
installed. Otherwise, only a test application will be installed.
Refer to the following images to perform setup and installation for Windows.
To Next Page
Loading...
