Asus B150M Pro Gaming - Page 54

2‑18
Chapter 2: BIOS Setup
1-Core Ratio Limit [Auto]
Congure the 1‑core ratio limit that must be higher than or equal to the 2‑core ratio limit.
2-Core Ratio Limit [Auto]
Congure the 2‑core ratio limit that must be higher than or equal to the 3‑core ratio limit. The
1‑core ratio limit must not be set to [Auto].
3-Core Ratio Limit [Auto]
Congure the 3‑core ratio limit that must be higher than or equal to the 4‑core ratio limit. The
1‑core and 2‑core ratio limit must not be set to [Auto].
4-Core Ratio Limit [Auto]
Congure the 4‑core ratio limit that must be lower than or equal to the 3‑core ratio limit. The
1‑core, 2‑core, and 3‑core ratio limit must not be set to [Auto].
2.5.2 BCLK Frequency: DRAM Frequency Ratio [Auto]
[Auto] The BCLK frequency to DRAM frequency ratio will be set to the optimized
setting.
[100:133] The BCLK frequency to DRAM frequency ratio will be set to 100:133.
[100:100] The BCLK frequency to DRAM frequency ratio will be set to 100:100.
2.5.3 DRAM Odd Ratio Mode [Enabled]
This item allows you to enable availability of odd DRAM ratios for improved granularity.
Conguration options: [Enabled] [Disabled]
2.5.4 DRAM Frequency [Auto]
This item allows you to select the DRAM operating frequency. The congurable options vary
with the BCLK (base clock) frequency setting. Select the auto mode to apply the optimized
setting.
Conguration options: [Auto][DDR4‑800MHz] [DDR4‑933MHz] [DDR4‑1066MHz]
[DDR4‑1200MHz] [DDR4‑1333MHz] [DDR4‑1400MHz] [DDR4‑1500MHz] [DDR4‑1600MHz]
[DDR4‑1700MHz] [DDR4‑1733MHz] [DDR4‑1800MHz] [DDR4‑1866MHz] [DDR4‑1900MHz]
[DDR4‑2000MHz] [DDR4‑2100MHz] [DDR4‑2133MHz] [DDR4‑2200MHz] [DDR4‑2266MHz]
[DDR4‑2300MHz] [DDR4‑2400MHz] [DDR4‑2500MHz] [DDR4‑2533MHz] [DDR4‑2600MHz]
[DDR4‑2666MHz] [DDR4‑2700MHz] [DDR4‑2800MHz] [DDR4‑2900MHz] [DDR4‑2933MHz]
[DDR4‑3000MHz] [DDR4‑3066MHz] [DDR4‑3100MHz] [DDR4‑3200MHz] [DDR4‑3333MHz]
[DDR4‑3466MHz] [DDR4‑3600MHz] [DDR4‑3733MHz] [DDR4‑3866MHz] [DDR4‑4000MHz]
[DDR4‑4133MHz] [DDR4‑4266MHz]
Selecting a very high memory frequency may cause the system to become unstable! If this
happens, revert to the default setting.