Asus B85M-VIEW PAKER - Chassis Intrusion Connector

1-20
Chapter 1: Product introduction
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connectoneendofthechassisintrusionsensororswitchcabletothis
connector.Thechassisintrusionsensororswitchsendsahigh-levelsignalto
thisconnectorwhenachassiscomponentisremovedorreplaced.Thesignal
isthengeneratedasachassisintrusionevent.
Bydefault,thepinslabeled“Intruder”areshortedwithajumpercap.Remove
the jumper caps only when you intend to use the chassis intrusion detection
feature.
Beforeusingthisfunction,ensurethatyouenableitfromMonitor > Chassis Intrude
SupportintheBIOSSetupprogram.
11. mSATA/mPCIe slot (MSATA_MPCIE)
ThisslotallowsyoutoinstallafulllengthmSATAormini-PCIecard,providingyouwith
expandabilityandconnectivitysolutionsforanoptimalsystemperformance.
B85M-VIEW PAKER
B85M-VIEW PAKER Chassis intrusion connector
PIN 1
+5VSB_MB Chassis Signal GND
CHASSIS
B85M-VIEW PAKER
B85M-VIEW PAKER mSATA/mPCIe combo slot
MSATA_MPCIE
YoucaninstalleitheranmSATAcardoranmPCIecardintothisslotoneatatime.