Asus H110I-PLUS D3 - Page 27

ASUS H110I-PLUS D3
1-19
11. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector.Thechassisintrusionsensororswitchsendsahigh-levelsignalto
thisconnectorwhenachassiscomponentisremovedorreplaced.Thesignal
isthengeneratedasachassisintrusionevent.
Bydefault,thepinslabeledIntruderareshortedwithajumpercap.Remove
the jumper caps only when you intend to use the chassis intrusion detection
feature.
H110I-PLUS D3
H110I-PLUS D3 Chassis intrusion connector
+5VSB_MB Chassis Signal GND
CHASSIS