38 ASUS TUSL2 User’s Manual
Connectors
3. H/W SETUP
3. HARDWARE SETUP
19) Wake-On-LAN Connector (3-pin WOL_CON)
This connector supplies a LAN card with a Wake-On-LAN output, such as the
ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up the
system when a wakeup packet or signal is received through the LAN card.
IMPORTANT: This feature requires that Wake On LAN or PCI Modem is
enabled (see 4.5.1 Power Up Control) and that your system has an ATX power
supply with at least 720mA +5V standby power.
20) Wake-On-Ring Connector (2-pin WOR_CON)
This connector supplies internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that Wake On LAN or PCI Modem is
enabled (see 4.5.1 Power Up Control) and that your system has an ATX power
supply with at least 720mA +5V standby power.
TUSL2-C
®
TUSL2-C Wake-On-Ring Connector
WOR
Ring# Ground
2
1
TUSL2-C
®
TUSL2-C Wake-On-LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
+5 Volt Standby
PME
Ground
WOL_CON
To Next Page