Asus M2N DH - Page 50

2-28 Chapter 2: Hardware information
9. ATX power connectors (24-pin ATXPWR, 4-pin EATX12V)
These connectors are for ATX power supply plugs. The power supply plugs
are designed to t these connectors in only one orientation. Find the proper
orientation and push down rmly until the connectors completely t.
R
M2N
M2N/M2N DH ATX Power Connector
+12V DC
GND
+12V DC
GND
ATX12V
+3 Volts +3 Volts Ground +5 Volts +5 Volts Ground Ground Power OK +5V Standby +12 Volts
-5 Volts
+5 Volts +3 Volts
-12 Volts
Ground Ground Ground
PSON#
Ground
+5 Volts
+12 Volts +3 Volts
+5 Volts
Ground
EATXPWR
• For a fully congured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specication 2.0 (or later version)
and provides a minimum power of 600 W.
• Do not forget to connect the 4-pin ATX +12 V power plug; otherwise, the
system will not boot.
• Use of a PSU with a higher power output is recommended when
conguring a system with more power-consuming devices. The system
may become unstable or may not boot up if the power is inadequate.