Asus M2N DH - Onboard Device Configuration

ASUS M2N / M2N DH 4-25
Hyper Transport MCP61 Conguration
MCP61(SB) to K8(CPU) Freq Auto [Disabled]
MCP61(SB) to K8(CPU) Frequency [1000 MHz]
MCP61(SB) to K8(CPU) LinkWidth [16
↑16↓]
Hyper Transport MCP61 Conguration
MCP61 (SB) to K8 (CPU) Freq Auto [Disabled]
Enables or disables the CPU to automatically adjust Hyper Transport frequency.
Conguration options: [Disabled] [Enabled]
MCP61 (SB) to K8 (CPU) Frequency [1000MHz]
Allows you to set the Hyper Transport frequency. This item appears when you set
the MCP61(SB) to K8(CPU) Freq Auto to Disabled.
Conguration options: [200 MHz] [400 MHz] [800 MHz] [1000 MHz].
MCP61 (SB) to K8 (CPU) LinkWidth [[16 16 ]]
Sets the Hyper Transport width.
Conguration options: [4 4 ] [8 8 ] [16 16 ]
4.4.4 Onboard Devices Conguration
Serial Port1 Address [3F8/IRQ4]
Parallel Port Address [378]
Parallel Port Mode [Normal]
Parallel Port IRQ [IRQ7]
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address. Conguration options:
[Disabled] [3F8/IRQ4][2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Parallel Port Address [378]
Allows you to select the Parallel Port base addresses.
Conguration options: [Disabled] [378] [278] [3BC]
Parallel Port Mode [Normal]
Allows you to select the Parallel Port mode.
Conguration options: [Normal] [EPP] [ECP] [EPP+ECP]