Asus M2N-VM DVI - Page 72

2-26 Chapter 2: BIOS setup
Memory Conguration
Select the DRAM
Frequency programing
method. If Auto,
the DRAM speed will
be based on SPDs.
If Limit, the DRAM
spe will not exceed
the specic value.
If Manual, the DRAM
specied will be
programmed regardless.
Memory Conguration
Memory Setting: 266MHz-4.0-4-4-11-2T
Memclock Mode [Auto]
CAS Latency (CL) [Auto]
TRCD [Auto]
TRP [Auto]
TRAS [Auto]
Command Timing (2T mode) [Auto]
MCT Timing Mode [Auto]
Bank Interleaving [Auto]
Enable Clock to All DIMMS [Disabled]
MemClk Tristate C3/ATLVID [Disabled]
Memory Hole Remapping [Enabled]
Memclock Mode [Auto]
Sets the memory clock mode.
Conguration options: [Auto] [Limit] [Manual]
The following item appears when the Memclock Mode is set to Limit or Manual.
Memclock Value [200 MHz]
Sets the memory clock mode limit.
Conguration options: [400 MHz] [533 MHz] [ 667 MHz] [ 800 MHz]
CAS Latency (CL) [Auto]
Sets the CAS Latency (CL) mode.
Conguration options: [Auto] [3.0] [4.0] [5.0] [6.0]
TRCD [Auto]
Sets the TRCD mode.
Conguration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRP [Auto]
Sets the TRP mode.
Conguration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRAS [Auto]
Sets the TRAS mode.
Conguration options: [Auto] [5 CLK] [6 CLK] ~ [18 CLK]