• For detailed instructions on RAID congurations, refer to the RAID manual in the
support DVD.
• If you intend to create a Serial ATA RAID set using these connectors, set the
OnChip
SATA Type item in the BIOS to [RAID]. See page 2-10 for details.
• If you want to do the task as GHOST, we suggest you connect the original
disk to the SATA5 or SATA6
5. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4, SATA5, SATA6)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
and optical disk drives. The Serial ATA 3Gb/s is backward compatible with Serial ATA
1.5Gb/s specication. The data transfer rate of the Serial ATA 3Gb/s is faster than the
standard parallel ATA with 133 MB/s (Ultra DMA133). If you install Serial ATA hard disk
drives, you can create a RAID 0, RAID 1, RAID 0+1, or JBOD conguration through the
onboard SB700 controller.
Install the Windows
®
XP Service Pack 2 or later version before using Serial ATA.
6. Optical drive audio in connector (4-pin CD)
This connector allows you to receive stereo audio input from sound sources such as a
CD-ROM, TV tuner, or MPEG card.
1-22 ASUS M3A78-CM
To Next Page
Loading...
