1-40 Chapter 1: Product introduction
13. ASUS Q-Connector (system panel)
You can use the ASUS Q-Connector to connect/disconnect chassis front
panel cables in a few steps. Refer to the instructions below to install the
ASUS Q-Connector.
1. Connect the front panel cables to the
ASUS Q-Connector.
Refer to the labels on the
Q-Connector to know the detailed pin
denitions, then match them to the
respective front panel cable labels.
2. Install the ASUS Q-Connector to the
system panel connector, making sure
the orientation matches the labels on
the motherboard.
3. The front panel functions are now
enabled. The gure shows the
Q-Connector properly installed on the
motherboard.
To Next Page
Loading...
