Asus M4A78 PLUS - Motherboard - ATX - Page 35

• For detailed instructions on RAID congurations, refer to the RAID manual in the
support DVD.
• If you intend to create a Serial ATA RAID set using these connectors, set the
OnChip
SATA Type select item in the BIOS to [RAID]. See page 2-9 for details.
3. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA5, SATA6)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
and optical disk drives. The Serial ATA 3Gb/s is backward compatible with Serial ATA
1.5Gb/s specication. The data transfer rate of the Serial ATA 3Gb/s is faster than the
standard parallel ATA with 133 MB/s (Ultra DMA133). If you install Serial ATA hard disk
drives, you can create a RAID 0, RAID 1, and RAID 0+1 conguration through the
onboard SB700 chipset.
SATA1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA3
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA5
GND
RSATA_TXP5
RSATA_TXN5
GND
RSATA_RXP5
RSATA_RXN5
GND
SATA6
GND
RSATA_TXP6
RSATA_TXN6
GND
RSATA_RXP6
RSATA_RXN6
GND
M4A78 PLUS
M4A78 PLUS SATA connectors
Install the Windows
®
XP Service Pack 1 before using Serial ATA.
Chapter 1: Product introduction 1-25