Asus MAXIMUS VI FORMULA - Page 109

ASUS MAXIMUS VI FORMULA
3-19
Chapter 3
Initial PLL Termination Voltage [Auto]
Initial Voltage at which CPU BCLKs are terminated. Maintaining a level close to CPU
Input Voltage will help BCLK Overclock.
Conguration options: [Auto] [0.0000] - [3.0000]
PLL Termination Reset Voltage [Auto]
PLL Termination Reset Voltage. Conguration options: [Auto] [0.00000] - [3.00000]
Eventual PLL Termination Voltage [Auto]
Eventual PLL Termination Voltage. Conguration options: [Auto] [0.00000] - [3.00000]
PCH ICC Voltage [Auto]
Power Supply for the Integrated Clock Controller. Lower may be better. Conguration
options: [Auto] [0.6000] -[2.2000]
ICC Ringback Canceller
Can be used to control the noise level at the Integrated Clock Controller.
Conguration options: [Enabled] [Disabled]
[Enabled] To allow better High DMI Frequency O.C.
[Disabled] To allow better Low DMI Frequency O.C.
Termination Anti-Aliasing
Can be enabled to smooth out the change of the PLL Termination Voltage, which may
sometimes help to yield a better O.C. result.
Clock Crossing VBoot [Auto]
The instantaneous voltage value when the rising edge of BCLK DN is equal to the
falling edge of the BCLK DP. Conguration options: [Auto] [0.1000] - [1.9000]
Clock Crossing Reset Voltage [Auto]
The instantaneous voltage value when the rising edge of BCLK DN is equal to the
falling edge of the BCLK DP. Conguration options: [Auto] [0.1000] - [1.9000]
Clock Crossing Voltage [Auto]
The instantaneous voltage value when the rising edge of BCLK DN is equal to the
falling edge of the BCLK DP. Conguration options: [Auto] [0.1000] - [1.9000]
PECI Voltage [Auto]
Power Supply for the Platform Environment Control Interface. Try to maintain 100mV to
close to PCH 1.05V Conguration options: [Auto] [0.3000] - [1.8000]
BCLK Amplitude [Auto]
Allows you to adjust the magnitude of the BCLK.
Conguration options: [Auto] [+5] - [-5]
DMI Gen 2 [Auto]
Allows you to enable or disable DMI Gen 2. Auto means Enabled. Conguration
options: [Auto] [Enabled] [Disabled]
DMI De-emphasis Control [-6 dB]
Congure De-emphasis control on DMI. Conguration options: [-6 dB] [-3.5 db]
SATA Drive Strength [Auto]
SATA Drive Strength. Conguration options: [Auto] [+10] - [-10]