Asus P10S-I - Page 100

4-44
Chapter 4: BIOS Setup
• The following items appears only when you set
SEL Components
to
[Enabled]
.
• Allvalueschangedheredonottakeeffectuntilcomputerisrestarted.
SEL Components [Enabled]
Allows you to enable or disable all features of System Event Logging during boot.
Congurationoptions:[Disabled][Enabled]
Erase SEL [No]
Allows you to choose options for erasing SEL.
Congurationoptions:[No][Yes,Onnextreset][Yes,Oneveryreset]
When SEL is Full [Do Nothing]
Allows you to choose options for reactions to a full SEL.
Congurationoptions:[DoNothing][EraseImmediately]
Log EFI Status Codes [Error code]
DisabletheloggingofEFIStatusCodes,orlogonlyerrorcode,oronlyprogresscode,or
both.
Congurationoptions:[Disabled][Both][Errorcode][Progresscode]
BMC network configuration
Thesub-itemsinthiscongurationallowyoutoconguretheBMCnetworkparameters.
DM_LAN1/Shared LAN
Config Address source [Previous State]
ThisitemallowsyoutocongureLANchannelparametersstatisticallyordynamically
(byBIOSorBMC).PreviousStateoptionwillnotmodifyanyBMCnetworkparameters
during BIOS phase.
Congurationoptions:[PreviousState][Static][DynamicBmcDhcp]