Asus P10S WS - Page 59

ASUS P10S WS
2-13
Chapter 2
Refer to section 1.2.8 Onboard LEDsformoreinformationoftheFlashbackLED.
IfthesystemfailstobootafterashingtheBIOS,unplugthepowercoreandrestartthe
system.
• Donotunplugportabledisk,powersystem,orpresstheCLR_CMOSbuttonwhile
BIOS update is ongoing, otherwise update will be interrupted. In case of interruption,
please follow the steps again.
• Ifthelightashesforvesecondsandturnsintoasolidlight,thismeansthat
theBIOSFlashbackisnotoperatingproperly.Thismaybecausedbyimproper
installationoftheUSBstoragedeviceandlename/leformaterror.Ifthisscenario
happens, please restart the system to turn off the light.
• UpdatingBIOSmayhaverisks.IftheBIOSprogramisdamagedduringtheprocess
and results to the system’s failure to boot up, please contact your local ASUS Service
Center.
For more BIOS update utilities in BIOS setup, refer to the section 3.11 Updating BIOS in
Chapter3.
6. Waituntilthelightgoesout,indicatingthattheBIOSupdatingprocessiscompleted.
5. Onyourmotherboard,presstheBIOSFlashbackbuttonforthreesecondsuntilthe
FlashbackLEDblinksthreetimes,indicatingthattheBIOSFlashbackfunctionis
enabled.