2-15ASUS Pundit P1-P5945G/P2-P5945G
Before reinstalling the storage drive assembly, connect the IDE/SATA and
power plugs to the IDE/SATA and power connectors at the back of the
drives.
1. Connect the black plug of the IDE cable to the optical drive, then the
gray plug to the hard disk drive. If you have the SATA HDD, connect
the SATA cable to the SATA HD.
2. Connect the 4-pin power plugs to the power connectors at the back
of the drives.
3. Install the storage drive assembly to the chassis.
3
4
4. Secure the storage drive assembly with three screws.
Follow these steps to reinstall the storage drive assembly:
To Next Page
Loading...
