1-301-30
1-301-30
1-30
Chapter 1: Hardware informationChapter 1: Hardware information
Chapter 1: Hardware informationChapter 1: Hardware information
Chapter 1: Hardware information
9.9.
9.9.
9.
Chassis intrusion connector (4-1 pin CHASSIS1)Chassis intrusion connector (4-1 pin CHASSIS1)
Chassis intrusion connector (4-1 pin CHASSIS1)Chassis intrusion connector (4-1 pin CHASSIS1)
Chassis intrusion connector (4-1 pin CHASSIS1)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “GND” (Ground) are
shorted with a jumper cap. Remove the jumper caps only when you
intend to use the chassis intrusion detection feature.
8.8.
8.8.
8.
Optical drive audio connector (4-pin CD1)Optical drive audio connector (4-pin CD1)
Optical drive audio connector (4-pin CD1)Optical drive audio connector (4-pin CD1)
Optical drive audio connector (4-pin CD1)
This connector is for the 4-pin audio cable that connects to the audio
connector at the back of the optical drive.
P5GD2-VM
®
P5GD2-VM CD audio connector
CD1
Right Audio Channel
Left Audio Channel
Ground
Ground
P5GD2-VM
®
P5GD2-VM Chassis intrusion connector
CHASSIS1
(Default)
+5VSB_MB
Chassis Signal
GND
To Next Page
Loading...
