Asus P5LD2-X GBL - 4.4.2 USB Configuration

ASUS P5LD2-X/GBL 4-19
4.4.2 USB Conguration
The items in this menu allows you to change the USB-related features. Select an
item then press <Enter> to display the conguration options.
The Module Version and USB Devices Enabled items show the
auto-detected values. If no USB device is detected, the item shows None.
USB Conguration
Module Version - 2.24.3-13.4
USB Devices Enabled:
None
USB Function [Enabled]
Legacy USB Support [Auto]
USB 2.0 Controller [Enabled]
USB 2.0 Controller Mode [HiSpeed]
BIOS EHCI Hand-Off [Enabled]
Options
Disabled
Enabled
DRAM Frequency [Auto]
Allows you to set the DDR2 operating frequency.
Conguration options: [Auto] [DDR2-400MHz] [DDR2-533 MHz] [DDR2-667 MHz]
The following item appears only when you set the AI Overclocking item to
[Manual].
CPU Frequency [266]
Displays the frequency sent by the clock generator to the system bus and PCI bus.
The value of this item is auto-detected by the BIOS. Use the <+> and <-> keys to
adjust the CPU frequency. You can also type the desired CPU frequency using the
numeric keypad. The values range from 133 to 400. Refer to the table below for
the correct Front Side Bus and CPU External Frequency settings.
PCI Express Frequency [Auto]
Allows you to select PCI express frequency. Conguration options: [Auto] [90] [91]
[92] [93] [94] [95] ~ [102] [103] [104]
Selecting a very high DRAM frequency may cause the system to become
unstable! If this happens, revert to the default setting.