Asus P5QPL-VM EPU - Page 53

ASUS P5QPL-VM EPU 2-11
Overclock Options [Overclock 5%]
Allows you to select the overclock options. Conguration options: [Overclock 5%]
[Overclock 10%] [Overclock 15%] [Overclock 20%] [Overclock 30%] [Test Mode]
Selecting a very high DRAM frequency may cause the system to become unstable! If this
happens, revert to the default setting.
The following item appears only when you set the AI Overclocking item to
[Overclock Prole].
FSB
DRAM Frequency
Auto 667MHz 800MHz 960MHz 1000MHz 1067MHz 1100MHz 1200MHz
1333 • • • • •
1066 • • • •
800 • • •
The DRAM Frequency options vary with different FSB values. Refer to the following table
for the DRAM Frequency options when the FSB value is 1333, 1066, and 800.
PCI Express Frequency [Auto]
Allows you to set the PCI Express frequency. Conguration options: [Auto] [90] ~ [150]
Memory Voltage [Auto]
Allows you to set the memory voltage. The values range from 1.50000V to 2.44500V with a
0.01500V increment. Use the <+> / <-> keys to adjust the value. Conguration options: [Auto]
[Max. = 2.44500V] [Min. = 1.50000V]
NB Voltage [Auto]
Allows you to select the North Bridge voltage. Conguration options: [Auto] [1.125V] [1.175V]
[1.225V] [1.275V]
SB 1.5V Voltage [1.5V]
Allows you to select the South Bridge voltage. Conguration options: [1.5V] [1.6V]
CPU VTT [1.2V]
Allows you to select FSB termination voltage. Conguration options: [1.2V] [1.3V]
CPU Over Voltage [Auto]
Allows you to select the CPU Over Voltage. Conguration options: [Auto] [+50mv] [+100mv]
[+150mv]
Auto PSI [Enabled]
Enables or disables auto PSI. When you set this item to [Disabled], power runs in the
xed 4 phase mode. When you set this item to [Enabled], power runs in the auto mode.
Conguration options: [Enabled] [Disabled]
DRAM Frequency [Auto]
Allows you to set the DDR2 operating frequency. Conguration options: [Auto] [667MHz]
[800MHz] [1067MHz]