1-28 Chapter 1: Hardware information
7. Front panel audio connector (10-1 pin FP_AUDIO)
This connector is for a chassis-mounted front panel audio I/O module
that supports legacy AC ‘97 audio standard. Connect one end of the
front panel audio I/O module cable to this connector.
P5VDC-TVM Front Panel Audio Connector
P5VDC-TVM
®
BLINE_OUT_L
MIC2
Line out_R
Line out_L
BLINE_OUT_R
NC
MICPWR
+5VA
AGND
FP_AUDIO
8. Serial port connector (10-1 pin COM2)
This connector is for a serial (COM) port. Connect the serial port
module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
P5VDC-TVM COM Port Connector
P5VDC-TVM
®
COM2
PIN1
Serial port module is purchased separately.
To Next Page
Loading...
