Asus P6T WS PRO - Marvell

ASUS P6T WS Professional 4-57
4.4.4 Marvell
®
SAS RAID congurations
The Marvell
®
88SE6320 SAS controller allows you to congure RAID 0 and 1 set
on the SAS hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set.
To do this:
1. Install two internal SAS hard disk drives to the SAS connectors labeled
SAS1/2.
2. Boot up your computer, and press <Del> during POST to enter the BIOS
setup.
3. In the Advanced menu, go to Onboard Devices Conguration, and enable
both Marvell SAS and SAS Boot ROM.
4. Press <F10> to save the changes and exit.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Congure Super IO Chipset
High Denition Audio [Enabled]
Front Panel Type [HD Audio]
Marvell Storage Controller [Enabled]
Marvell Storage Boot Rom [Enabled]
Marvell SAS [Enabled]
SAS Boot ROM [Enabled]
Marvell LAN1 [Enabled]
Marvell LAN2 [Enabled]
LAN Boot ROM [Disabled]
Onboard 1394 Controller [Enabled]
Enable or Disable
High Denition Audio
Controller
BIOS SETUP UTILITY
Advanced
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.