4. Marvell
®
88SE6320 SAS RAID connectors [black] (7-pin SAS1-2)
These connectors are for SAS (Serial Attached SCSI) signal cables that
support SAS hard disk drives. To congure RAID 0 or RAID 1, install two SAS
hard disk drives to these two connectors.
Before creating a RAID set using SAS hard disk drives, ensure that you have
connected the SAS signal cables and installed SAS hard disk drives; otherwise,
you cannot enter the Marvell RAID utility and SAS BIOS setup during POST.
• When ICH10R SATA ports are set to RAID or AHCI mode, SAS HDDs can
be detected in Windows environment only.
• Please install the Marvell
®
Controller driver before using the black SAS
RAID connectors (SAS1-2). See section 4.2.2 Drivers menu for details.
• Before creating a RAID set, see section 4.4.5 Marvell
®
SAS RAID
congurations for details..
2-26 Chapter 2: Hardware information
To Next Page
Loading...
