Asus P8P67 LE - Page 46

ASUS P8P67 LE1-34
10. Marvell
®
Serial ATA 6.0Gb/s connector (7-pin SATA6G_E1 [navy blue])
This connector connects to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s
signal cables.
• The SATA6G_E1 (navy blue) connector is for data drives only. ATAPI device is not
supported.
• You must install Windows
®
XP Service Pack 3 or later versions before using Serial ATA
hard disk drives.
• When using hot-plug and NCQ, set the Marvell Storage Controller item in the BIOS to
[AHCI Mode]. Refer to section 2.5.6 Onboard Devices Conguration for details.
• Press <Ctrl> + <M> during POST to enter the Marvell RAID utility to create or delete a
RAID conguration.
• If you want to install a Windows operating system to a RAID conguration created
using the Marvell SATA controller, you have to create a RAID driver disk using the
motherboard support DVD and load the driver during OS installation. For 32/64bit
Windows XP OS, load rst the Marvell shared library driver, and then load Marvell
91xx SATA Controller Driver. For Windows Vista / Windows 7 OS, load only the
Marvell 91xx SATA Controller Driver.
P8P67 LE
SATA6G_E1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
P8P67 LE Marvell
®
SATA 6.0 Gb/s connecto
r