Asus P8P67 REV 3.1 - Page 42

2-24 Chapter 2: Hardware information
Chapter 2
3. Marvell
®
Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1/E2 [navy blue])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• The SATA6G_E1/E2 (navy blue) connectors are for data drives only. ATAPI device is
not supported.
• You must install Windows
®
XP Service Pack 3 or later versions before using Serial ATA
hard disk drives.
• When using NCQ, set the
Marvell Storage Controller
item in the BIOS to [AHCI
Mode]. Refer to section
3.5.7 Onboard Devices Conguration
for details.