Asus P8P67 WS Revolution - Page 45

3. Marvell
®
Serial ATA 6.0 Gb/s connectors
(7-pin SATA6G_E1/E2 [navy blue])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
• These connectors are set to [AHCI] by default.
• You must install Windows
®
XP Service Pack 3 or later versions before using
Serial ATA hard disk drives.
• Before creating a RAID set, refer to section  or
the manual bundled in the motherboard support DVD.
• When using hot-plug and NCQ, set the Marvell Controller item in the BIOS
to [AHCI Mode]. Refer to section 
for details.
ASUS P8P67 WS Revolution 2-19