2-28 Chapter 2: Hardware information
Chapter 2
3. Marvell
®
Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_E1/E2 [gray])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• For high performance of ASUS SSD Caching, please connect one HDD and one SSD
to Marvell
®
SATA6G_E1/E2 connectors.
• For regular usage, the SATA6G_E1/E2 connectors are recommended for data drivers.
•
You must install Windows
®
XP Service Pack 3 or later versions before using Serial ATA
hard disk drives.
• Press <Ctrl> + <M> during POST to enter the Marvell RAID utility to create or delete a
RAID configuration.
• If you want to install a Windows operating system to a RAID configuration created
using the Marvell SATA controller, you have to create a RAID driver disk using the
motherboard support DVD and load the driver during OS installation. For 32/64bit
Windows XP OS, load first the
Marvell shared library
driver, and then load
Marvell
91xx SATA Controller Driver
. For Windows Vista / Windows 7 OS, load only the
Marvell 91xx SATA Controller Driver
.
To Next Page
Loading...
