Asus Prime A320I-K - Motherboard Component Details: Memory and Storage; DIMM Slots and Storage Interfaces

ASUS PRIME A320I-K
1-3
DDR4 DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these
DIMM sockets.
For more details, refer to System memory.
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of
the system setup information such as date, time, and system
passwords.
ToerasetheRTCRAM:
1. Turn OFF the computer and unplug the power cord.
2. Use a metal object such as a screwdriver to short the two
pins.
3. Plug the power cord and turn ON the computer.
4. Hold down the <Del> key during the boot process and enter
BIOS setup to re-enter data.
CLRTC
+3V_BAT GND
PIN 1
If the steps above do not help, remove the onboard battery and short the two pins again
to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
Speaker connector (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
AMD A320 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
USB 3.1 Gen 1 connector (20-1 pin USB3_12)
This connector allows you to connect a USB 3.1 Gen 1 module for additional USB
3.1 Gen 1 front or rear panel ports. With an installed USB 3.1 Gen 1 module, you
can enjoy all the benets of USB 3.1 Gen 1 including faster data transfer speeds
of up to 5Gbps, faster charging time for USB-chargeable devices, optimized power
efciency and backward compatibility with USB 2.0.
M.2 socket 3
This socket allows you to install M.2 (NGFF) SSD modules.
• This M.2 socket supports M Key and 2242/2260/2280
storage devices.
• Due to CPU limitation, M.2 socket supported varies by
processor.Refer to the specications summary table for
more details.
M.2(SOCKET3)