Asus PRIME H510T2-CSM R2.0 - Internal and System Panel Connectors; Power Connectors; M.2 Slot (Key M); SATA 6 Gb;s Port

1-3
4. Power connectors
These Power connectors allow you to connect your motherboard to a power supply. The
power supply plugs are designed to t in only one orientation. Find the proper orientation and
push down rmly until the power supply plugs are fully inserted.
These power connectors support 19V. Refer to the specication sheet for more details.
5. M.2 slot (Key M)
The M.2 slot allows you to install a M.2 device such as a M.2 SSD module.
Intel
®
H470 Chipset
M.2 slot (Key M), type 2260/2280 (supports PCIe 3.0 x4 & SATA modes)
The M.2 SSD module is purchased separately.
6. SATA 6Gb/s port
The SATA 6Gb/s port allows you to connect SATA devices such as optical disc drives and
hard disk drives via a SATA cable.
7. USB 3.2 Gen 1 header
The USB 3.2 Gen 1 header allows you to connect USB 3.2 Gen 1 modules
for additional USB 3.2 Gen 1 ports. The USB 3.2 Gen 1 header provides
data transfer speeds of up to 5 Gb/s.
The USB 3.2 Gen 1 module is purchased separately.
8. USB 2.0 headers
The USB 2.0 headers allow you to connect USB modules for additional USB 2.0
ports. The USB 2.0 headers provide data transfer speeds of up to 480 Mb/s.
DO NOT connect a 1394 cable to the USB connectors. Doing so will damage
the motherboard!
The USB 2.0 module is purchased separately.
9. Battery connector
This connector is for the lithium CMOS battery.
10. Backlight Inverter Voltage Selection header
1 2
2 3
12V
(Default)
19V
BLKT_PWR_SEL
PIN 1
Pins Setting
1-2 (Default) 12V
2-3 19V
GND
IntA_P3_D+
IntA_P3_D-
GND
IntA_P3_SSTX+
IntA_P3_SSTX-
GND
IntA_P3_SSRX+
IntA_P3_SSRX-
USB3+5V
PIN 1
IntA_P4_D+ IntA_P4_D- GND IntA_P4_SSTX+ IntA_P4_SSTX- GND IntA_P4_SSRX+ IntA_P4_SSRX- USB3+5V
U32G1_34
USB+5V USB_P7- USB_P7+ GND NC
USB+5V
USB_P8-
USB_P8+
GND
PIN 1
USB_78
PIN 1
VBAT GND
BATT_CON
PRIME H510T2-CSM R2.0