1-7
1.2.2 Rear panel connectors
1 2 4 65 7 83
2
1. DC power connector. Insert the power adapter into this port.
• Supports 19V DC input.
• The power adapter is purchased separately.
• Use the appropriate DC power adapter for the following scenarios:
- Use a 120W adapter when a 35W CPU is installed on the system.
- Use a 120W adapter when using your system with an LVDS panel.
- Use a high-rated adapter (above 120W) when a 65W CPU is installed on the
system.
2. HDMI™ ports. These ports are for High-Denition Multimedia Interface (HDMI™)
connectors, and are HDCP compliant allowing playback of HD DVD, Blu-ray, and other
protected content.
3. Video Graphics Adapter (VGA) port. This 15-pin port is for a VGA monitor or other
VGA-compatible devices.
4. USB 3.2 Gen 1 (up to 5Gbps) ports. These Universal Serial Bus (USB) ports connect
to USB 3.2 Gen 1 devices.
5. Realtek RTL8111H 1Gb Ethernet port. This port allows 1Gbps Ethernet connection
to a Local Area Network (LAN) through a network hub. Refer to the table below for the
Ethernet port LED indications.
Realtek RTL8111H 1Gb Ethernet port LED indications
Speed LED
Status Description
OFF
10 Mbps connection
ORANGE
100 Mbps connection
GREEN
1 Gbps connection
Activity Link LED
Status Description
OFF No link
ORANGE Linked
BLINKING Data activity
ACT/LINK
LED
SPEED
LED
LAN port
PRIME H510T2-CSM R2.0