Asus Pro WS C246-ACE - Page 15

ASUS Pro WS C246-ACE
1-5
Clear RTC RAM (2-pin CLRTC)
ThisheaderallowsyoutocleartheCMOSRTCRAMdataof
thesystemsetupinformationsuchasdate,time,andsystem
passwords.
To erase the RTC RAM:
1. TurnOFFthecomputerandunplugthepowercord.
2. Useametalobjectsuchasascrewdrivertoshortthetwo
pins.
3. PlugthepowercordandturnONthecomputer.
4. Holddownthe<Del> key during the boot process and
enterBIOSsetuptore-enterdata.
CLRTC
+3V_BAT GND
PIN 1
Ifthestepsabovedonothelp,removetheonboardbatteryandshortthetwopinsagain
tocleartheCMOSRTCRAMdata.AfterclearingtheCMOS,reinstallthebattery.
Thermal Sensor connector (2-pin T_SENSOR)
TheThermalSensorconnectorallowsyoutoconnecta
sensortomonitorthetemperatureofthedevicesandthe
critical components inside the motherboard. Connect the
thermalsensorandplaceitonthedeviceorthemotherboard’s
component to detect its temperature.
USB 2.0 connector (10-1 pin USB1112; USB1314)
ConnectaUSBmodulecabletothisconnector,then
install the module to a slot opening at the back of the
systemchassis.ThisUSBconnectorscomplywith
USB2.0specicationsandsupportsupto480Mbps
connection speed.
USB+5V USB_P13- USB_P13+ GND NC
USB+5V
USB_P14-
USB_P14+
GND
USB1314
PIN 1
USB+5V USB_P11- USB_P11+ GND NC
USB+5V
USB_P12-
USB_P12+
GND
USB1112
PIN 1
Node connector (12-1 pin NODE)
TheNodeconnectorallowsyoutoconnectNode
compatibledevices.
Visitwww.asus.comformoreinformationaboutthedevicesandthelatestcompatibility
list.