3-16
Chapter 3: BIOS Setup
Chapter 3
SATA6G_1(Gray) - SATA6G_4(Gray)
SATA6G_1 - SATA6G_4
This item allows you to enable or disable the selected SATA port.
Conguration options: [Disabled] [Enabled]
Hot Plug
These items appears only when the SATA Mode is set to [AHCI] and allows you to
enable or disable SATA Hot Plug Support.
Conguration options: [Disabled] [Enabled]
3.6.4 Onboard Devices Configuration
The items in this menu allow you to switch between PCIe Lanes and congure onboard
devices.
HD Audio Controller
This item allows you to use the Azalia High Denition Audio Controller
Conguration options: [Disabled] [Enabled]
Audio Jack LED Lighting
This item allows you to turn the RGB LED lighting for the Audio Jack LED on or off.
[Disabled] The audio jack LEDs will not light up.
[Auto] The audio jack LEDs will light up.
The audio jack LEDs will light up during S0(Working), S3(Sleep), S4(Hibernation), S5(Soft
off) states. The LEDs will not light up when ErP Ready is Enabled at S5 state, or S4 and
S5 state.
M.2_2 PCIe Bandwidth Configuration
[Auto] Auto-detects the M.2_2 slot. If an M.2 device is detected,
PCIEX16 will run at x8 mode, respectively.
[Disabled(X16 mode)] Disable M.2_2 for PCIEX16 running on high performance. (x16)
PCIEX16 Mode
This item allows you to set the link speed for PCIEX16/X8_1 slot.
Conguration options: [Auto] [GEN 1] [GEN 2] [GEN 3]
M.2_1 Link Mode
This item allows you to set the link speed for M.2_1 Device.
Conguration options: [Auto] [GEN 1] [GEN 2] [GEN 3]
M.2_2 Link Mode
This item allows you to set the link speed for M.2_2 Device.
Conguration options: [Auto] [GEN 1] [GEN 2] [GEN 3]
SB Link Mode
This item allows you to set the link speed for Southbridge.
Conguration options: [Auto] [GEN 1] [GEN 2] [GEN 3]