Asus ROG STRIX X570-E GAMING - Headers and Jumpers; Q-Code LED Error Display; Clear CMOS RTC RAM Jumper

1-10
Chapter 1: Product Introduction
Chapter 1
5. Q-Code LED
TheQ-CodeLEDdesignprovidesyouwitha2-digiterrorcodethatdisplaysthesystem
status.RefertotheQ-Codetableonthenextpagefordetails.
STRIX X570-e GAMING
ROG STRIX X570-E GAMING Q-Code LED
1.1.7 Headers
1. Clear RTC RAM jumper (2-pin CLRTC)
ThisjumperallowsyoutocleartheCMOSRTCRAMdataofthesystemsetup
informationsuchasdate,time,andsystempasswords.
ToerasetheRTCRAM:
1. TurnOFFthecomputerandunplugthepowercord.
2. Useametalobjectsuchasascrewdrivertoshortthetwopins.
3. PlugthepowercordandturnONthecomputer.
4. Holddownthe<Del>keyduringthebootprocessandenterBIOSsetuptore-enter
data.
Ifthestepsabovedonothelp,removetheonboardbatteryandshortthetwopinsagainto
cleartheCMOSRTCRAMdata.AfterclearingtheCMOS,reinstallthebattery.
STRIX X570-e GAMING
ROG STRIX X570-E GAMING Clear RTC RAM
CLRTC
+3V_BAT GND
PIN 1