2-4
Chapter 2: Setup
After adjusting the tilt strength by inbox Allen wrench, following below to
assemble ball shaft back
NOTE:
• ROG tripod supports tilt -5~90 degrees and swivel 360 degrees.
• ROG tripod can be the stand for products that implement standard
tripod hole.
• When the ball shaft is removed, it becomes a standard tripod, a
standard 1/4 thread is seen embedded.
• ROG tripod can only support product that is within 1.5kg, please don’t
connect with product that is over this weight.
CAUTION: ROG tripod doesn’t support Pivot function, please
don’t turn the monitor in clockwise or counterclockwise when
connecting with ROG tripod in case of any damage.
To Next Page
Loading...
