Asus ROG STRIX Z490-E - Page 54

54
ROG STRIX Z490-E BIOS Manual
LED lighting
When system is in working state
This item allows you to turn the RGB LED lighting on or off when the system is in the
working state.
[All On]: RGB LEDs and Functional LEDs will behave normally.
[Stealth Mode]: All LEDs will be disabled.
[Aura Only]: RGB LEDs will light up, while all functional LEDs will be
disabled.
[Aura Off]: Functional LEDs behave normally, while RGB LEDs will be
disabled.
The RGB Header(s) and Addressable Header(s) will only work under the S0 (working)
state.
Q-Code LED Function
[Disabled] Disable the Q-Code LED.
[POST Code Only] Show POST (Power-On Self-Test) code on Q-Code LED.
[Auto] Automatically display POST (Power-On Self-Test) code and
CPU temperature on Q-Code LED.
When system is in sleep, hibernate or soft off states
This item allows you to turn the RGB LED lighting on or off when the system is in the
sleep, hibernate or soft off states.
[All On]: RGB LEDs and Functional LEDs will behave normally.
[Stealth Mode]: All LEDs will be disabled.
[Aura Only]: RGB LEDs will light up, while all functional LEDs will be
disabled.
[Aura Off]: Functional LEDs behave normally, while RGB LEDs will be
disabled.
The RGB Header(s) and Addressable Header(s) will only work under the S0 (working)
state.
M.2_1 Configuration
[Auto] Auto-detects the M.2 device mode. If a SATA device is detected,
SATA6G_2 will be disabled.
[SATA mode] Only supports M.2 SATA devices. Please note that SATA6G_2 port
cannot be used in this mode.
[PCIE mode] Only supports M.2 PCIE devices.
When M.2_1 is populated by an Intel Optane Memory H10, M.2_1 will be set to [Auto].
M.2_2 Configuration
[Auto] This Auto Mode will allow M.2_2 to support either an NVMe M.2 device
(running at PCIe X2).
[X4 Mode] When X4 Mode is enabled, M.2_2 supports NVMe M.2 storage only
(running at PCIe X4), and SATA port 5 and 6 will also be disabled.