To Next PageTo Next Page
Need help?Do you have a question about the Asus RT-N12+ B1 and is the answer not in the manual?
General| Wireless Standard | IEEE 802.11b/g/n |
|---|---|
| Frequency Band | 2.4 GHz |
| Data Rate | Up to 300 Mbps |
| LAN Ports | 4 x 10/100 Mbps |
| WAN Port | 1 x 10/100 Mbps |
| Memory | 8 MB Flash, 32 MB RAM |
| WAN Connection Type | Automatic IP, Static IP, PPPoE (MPPE supported), PPTP, L2TP |
| Antennas | 2 x 5 dBi fixed antennas |
| Operating Modes | Router, Repeater, Access Point |
| Security | WEP, WPA, WPA2 |
| Firewall & Access Control | URL filter |
| Management | Web-based GUI |
| VPN Support | L2TP Pass-through |
Unplug your cable/DSL modem and remove the battery if it has one.
Use the network cable to connect your modem to the router.
Turn on your cable/DSL modem to establish a connection.
Check the modem's LED lights to ensure the connection is active.
Plug the power adapter into the router and then into a wall socket.
Verify WAN and 2.4G LED lights indicate a ready hardware connection.
Connect your PC to the router via Wi-Fi or an Ethernet cable.
Open a web browser and navigate to http://router.asus.com.
Use 'admin' for both username and password to log in.
Change default passwords for security and reboot the router.
