1-20
Chapter 1: Product Introduction
Chapter 1
3. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
The S/PDIF module is purchased separately.
4. Thermal Sensor connectors (2-pin T_SENSOR1; T_SENSOR2; T_SENSOR3)
These connectors are for the thermistor cables that monitor the temperature of the
devices and the critical components inside the motherboard. Connect the thermistor
cable and place the sensor on the device or the motherboard’s component to detect its
temperature.
To Next Page
Loading...
