Asus SABERTOOTH Z97 MARK 2/USB 3.1 - Page 118

ASUS SABERTOOTH Z97 MARK 2/USB 3.1
3-49
Chapter 3
Allow Fan Stop 1/3 [Disabled]
These items allow the chassis fans to run at 0% duty cycle when the
temperature of the source is dropped below the lower temperature.
Conguration options: [Disabled] [Enabled]
ASST Fan 1/2 Q-Fan Control [Enabled]
These items allow you to set the assistant fans’ Q-Fan control feature into DC Mode, PWM
Mode, or disable these Q-Fan controls from your motherboard.
Conguration options: [Disabled] [DC Mode] [PWM Mode]
The following items appear only when you set the Assistant Fan 1/3 Q-Fan Control to
[PWM Mode] or [DC Mode].
ASST Fan 1/2 Q-Fan Source [DC Mode]
This item controls the assigned fan according to the selected temperature source.
Conguration options: [CPU] [MB] [VCORE] [VCORE (BACK)] [DRAM] [PCH Core]
[USB3.0] [PCIE-1] [PCIE-2] [T_Sensor1] [T_Sensor2] [T_Sensor3]
If you select T_SENSOR 1/3, plug a thermistor cable to T_SENSOR 1/3 headers and stick
the thermistor cable’s head to the desired component as the temperature source.
ASST Fan 1/2 Speed Low Limit [300 RPM]
This item allows you to disable or set the assistant fans’ warning speed.
Conguration options: [Ignore] [200 RPM] [300 RPM] [400 RPM] [500 RPM] [600 RPM]
ASST Fan 1/2 Profile [Standard]
This item allows you to set the appropriate performance level of the assistant fans.
[Standard] Set to make the assistant fan adjust automatically depending on the
chassis temperature.
[Silent] Set to minimize the fan speed for quiet assistant fan operation.
[Turbo] Set to achieve maximum assistant fan speed.
[Manual] Set to assign detailed fan speed control parameters.
The following items appear only when you set the ASST Fan 1/2 Prole to [Manual].
ASST Fan 1/2 Upper Temperature [70]
Use the <+> or <-> keys to adjust the upper limit of the CPU temperature.
The values range from 40°C to 90°C.
ASST Fan 1/2 Max. Duty Cycle(%) [100]
Use the <+> or <-> keys to adjust the maximum assistant fan duty cycle.
The values may differ via Qfan tuning.
ASST Fan 1/2 Middle Temperature [45]
Use the <+> or <-> keys to set the value for ASST Fan Middle
Temperature.
ASST Fan 1/2 Middle Duty Cycle(%) [60]
Use the <+> or <-> keys to adjust the chassis fan middle duty cycle. The
values may differ via Qfan tuning.