1-14
1.5 M.2 installation
1
2
1
• Use a Phillips screwdriver when removing or installing the screws or screw stands
mentioned in this section.
• The M.2 is purchased separately.
1. Completely loosen the screws on the heatsink.
2. Remove the heatsink.
3. Install your M.2 to your M.2 slot(s).
For 2280, 22110 length
A. (optional) Remove the pre-installed removable M.2 Q-Latch screw at
the 2280 length screw hole.
Follow step A only when you wish to install an 22110 length M.2 to M.2_2
B. (optional) Install the bundled rubber for M.2 if you are installing a
single sided M.2 storage device. DO NOT install the bundled rubber
for M.2 when installing a double-sided M.2 storage device. The rubber
installed by default is compatible with double sided M.2 storage
devices.
C. Rotate and adjust the M.2 Q-latch so that the handle points away from
the M.2 slot.
D. Install your M.2 to the M.2 slot.
E. Rotate the M.2 Q-Latch clockwise to secure the M.2 in place.
OPTIONAL
B
A
C
D
E
Chapter 1: Product Introduction
To Next Page
Loading...
