1-12
For 2242, 2260 length
A. Install the bundled screw stand to the M.2 length screw hole you wish
to install your M.2 to.
B. Install your M.2 to the M.2 slot.
C. Secure your M.2 using the bundled screw stand’s screw.
1.5 M.2 installation
2
1
1
1
1
2
• Use a Phillips screwdriver when removing or installing the screws or screw stands
mentioned in this section.
• The M.2 is purchased separately.
1. Completely loosen the screws on the heatsink(s).
2. Remove the heatsink(s).
3. Install your M.2 to your M.2 slot(s).
For 2280 length
A. Rotate and adjust the M.2 Q-latch so that the handle points away from
the M.2 slot(s).
B. Install your M.2 to the M.2 slot(s).
C. Rotate the M.2 Q-Latch(es) clockwise to secure the M.2 in place.
Chapter 1: Product Introduction
To Next Page
Loading...
